Samsung RF56M9540SR Benutzerhandbuch Seite 36

Installation
STEP 2 Flooring
NOTE
If the refrigerator cannot pass through the entrance due to its size, see the Door removal
for entrance section in the Installation chapter.
STEP 3 Adjust the levelling legs
CAUTION
• The refrigerator must be levelled on a flat, solid floor. Failing to do so can cause
damage to the refrigerator or physical injury.
• Levelling must be performed with an empty refrigerator. Make sure no food items
remain inside the refrigerator.
• For safety reasons, adjust the front side a little higher than the rear side.
The refrigerator can be levelled using the front legs that have a special screw (leveller) for
levelling purposes. Use a flat-head screwdriver for levelling.
36 English
Untitled-19 36
• The surface to install the refrigerator
must support a fully loaded refrigerator.
• To protect the floor, put a large piece
of cardboard on each leg of the
refrigerator.
• Once the refrigerator is in its final
position, do not move it unless
necessary to protect the floor. If you
have to, use a thick paper or cloth such
as old carpets along the movement
path.
• To adjust the height of the left side:
Insert a flat-head screwdriver into the
leveller of the left side front leg. Turn
the leveller clockwise to raise, or turn it
counter clockwise to lower.
• To adjust the height of the right side:
Insert a flat-head screwdriver into the
leveller of the right side front leg. Turn
the leveller clockwise to raise, or turn it
counter clockwise to lower.
2017-06-28 2:52:47