Austroflamm WiRCU-BOX Benutzerhandbuch Seite 38

1 | Mounting the WiRCU-BOX
38
EN
11) Wait until the message "Settings successfully transmit-
ted to WiRCU-Box" appears. Then press "Finished".
12) Now disconnect the data cable from the WiRCU-Box.
Then shortly after, reconnect the cable.
13) Now wait until all 3 LEDs on the top of your WiRCU-
Box are permanently lit. (If this is not the case, repeat
the process according to the section
ð How to create the connection to your WLAN net-
work using an iOS device [}on page 34]
and/or follow the section
ð The WLAN network "WiRCU-XXXXXX" is not found
[}on page 40]).
14) Now enter the MAC address and PIN number of your
WiRCU-Box in the window that appears.
You can read this data on the side of the WiRCU-Box
or on the information card included in the delivery.
WiRCU-BOX