MSW Motor Technics MSW-PLT-6 Bedienungsanleitung Seite 42

WARNING: It is forbidden to use this product in cars, caravans, truck, tents
etc.
ATTENTION! If installation has not been carried out in accordance with the
procedures indicated, in the event of failure power supply, it may happen that
some of the exhaust gases penetrate into the room. In some cases it may be
necessary to install a UPS unit to maintain the draft.
Expondo shall not be held liable in any way whatsoever for damage to persons or
objects resulting from non-compliance with the rules described in the
aforementioned points and for products not installed in accordance with the
standards.
3. Instructions for use
The device is designed to generate heat for heating buildings and water by
burning pellets. It is suitable for permanent installation in buildings, however, it
is not suitable for use in prefabricated houses.
IMPORTANT: the product is designed to burn only wood pellets, do not use other
types of pellets and wood. We recommend using pellets that meet (or exceed) the
following standards:
Moisture content (after combustion) according
to CEN/TS 14774-1 and ISO 687
Ash content (after combustion) according to ISO
1171
Volatile matter content (dry, ashless base)
according to ISO 562
Hydrogen content (after combustion) according
to ISO 609
Carbon content (after combustion) according to
ISO 609
Sulfur content (after combustion) according to
ISO 351 and ISO 334
Calorific value according to ISO 1928
Diameter
Length
Use of moist and/or contaminated pellets (e.g. high salt or sand content) will
worsen the operation and performance of the unit. Also, improper storage of
EN
≤12%
≤0.7% (without bark)
≤2.0% (with bark)
80% to 88%
5.0% to 6.5%
40% to 50%
≤0.1%
16,900 KJ/kg to 19,500
KJ/kg
6 mm
≤40 mm