Taurus HYDRA SMILE Gebrauchsanleitung Seite 10

PERIODONTAL NOZZLE (K2)
• The periodontal nozzle delivers water
or anti-bacterial solutions deep into
periodontal pockets.
• Select the lowest pressure setting
(number 1 and SOFT mode)
• Lean low over your sink and place
the soft nozzle gainst a tooth at a
45-degree angle and gently place the
tip under the gum line inserting the
nozzle between teeth.
• Continue tracing along the gum line
until you finish cleaning.
ORTHODONTIC NOZZLE (K3)
• This nozzle is uniquely designed to
simultaneously brush and rinse hard-to-
reach areas around braces and other
dental work.
• Lean low over the sink and use the
brush bristles to clean around dental
work, water will flow through the brush
to rinse away any debris.
TONGUE CLEANER (K4)
• Lean low over your sink, place the
tongue cleaner on your tongue and start
the appliance on the lowest pressure
setting, increase as confortable.
• Place the tongue cleaner in the center
of your tongue about half way back and
pull forward with light pressure.
NOZZLE STORAGE PANEL (FIG.2)
• The nozzle storage panel can be taken
out by pulling out the buckle.
• You can take a nozzle out from the
panel early before wash and change
the nozzle more conveniently. Or
storage the nozzle in the accessory
box.
USE
• Extend the supply cord completely
before plugging it in.
• Connect the appliance to the mains.
• Guide the appliance to direct the flow
of water in the desired direction. The
direction of the water flow can be
controlled by rotating the the 360º
nozzle dial.
• Switch the unit on by selecting the ON
setting on the ON/OFF selector knob.
• Select the desired mode in the mode
touch control between: NORMAL,
SOFT and PULSE.
• To start the water flow, turn on the start/
stop switch.
• When the water flow and the gums are
at a 90-degree angle, slightly close
you mouth in order to avoid the water
spraying out, yet let the water flow from
the corner of the mouth into de sink.
STAND-BY FUNCTION
• In order to save energy, the appliance
passes to stand-by after 3 minutes.
• To turn it on again, you simply have to
switch the ON/OFF selector knob back
to the OFF setting, then turn it in a
clockwise direction again.
ONCE YOU HAVE FINISHED USING
THE APPLIANCE
• Stop the appliance by using the start/
stop switch.