Bellcome Standard 3.5”VIDEOTÜRSPRECHANLAGEN SET1 Familie Benutzerhandbuch Seite 28

Significance of LEDs signaling on SCU
BUTTON LED
PROG PROG
Long press
RED
When a battery is connected to SCU, there are the following additional signals only for S3 LED:
For LEDs signaling RED, see ch. 7 – Troubleshooting.
6.4. Use of the outdoor panel (VPT)
TORX Fixing screw
IR LEDs (night lighting)
+ - ( )
25 Adjustable Video camera o
Resident name
TORX Fixing screw
! It must be screwed completely
- Antitheft alarm protection
6.4.1 Functioning
STAND-BY
CALL
END CALL
TALK
ACCESS being granted
LED LED
S1 S2
GREEN GREEN
GREEN GREEN
GREEN GREEN
Name 1
The call key and the resident name are permanently backlit.
The RED LED is blinking.
Short touch of
Each touch of the key reactivates the call.
After 1 min. since the last call.
The resident answers
any key. The talk duration is max. 2 min.
The lock is open for the set temporization on SCU (between 1 and
10 sec.). The panel emits a sequence of beeps for confirmation.
LED
S3
The system is not connected to the 230 Va.c./
50 Hz network.
The system is OK, connected to the 230 Va.c./
50 Hz network.
Programming mode
(The kit is already programmed.)
The system is not connected to the 230 Va.c./
50 Hz network. The battery is functional.
GREEN
The system works only on audio and door
opening, for a limited time slot.
The system is OK, connected to the 230 Va.c./
GREEN
50 Hz network. The battery is functional.
The system is OK, connected to the 230 Va.c./
RED
50 Hz network. Battery charging or defect.
Microphone
Red LED (signaling the possibility of video
monitoring)
Call key (touch)
Loudspeaker
Acoustical signaling with a ding-dong.
Hands-free conversation, without touching
26