Display Settings - Beeper Speed Einrichtungs- & Benutzungshandbuch

DISPLAY SETTINGS

You can configure certain options on your scooter via your display. Attention, these operations must be done with
precaution because they affect the internal settings of the scooter.
&
Press ON / OFF and M at the same time. Once the menu displays P1, click on the ON / OFF button to change the
parameter. To modify the data, press M.
P02: Distance unit
0: Kilometers
1: Miles
P04: Standby
0: The scooter never goes to sleep
From 1 to 60: In minutes, the time elapsed before the scooter goes to sleep
P09: Starting the scooter with or without impulse
0: Off
1: On
P12: Starting power from 0 to 5
0: Very low
1: low
2: Medium
3: Strong
4: Very strong
5: Powerful
P16: Cruise control
0: Off
1: On
To activate the option, keep the throttle trigger actuated at the same speed for 3 seconds,
an indicator light comes on to let you know that the regulator is on. To deactivate it, simply brake or accelerate.
The other parameters MUST NOT be modified under any circumstances, otherwise the complete configuration of the
scooter may be disturbed.
Simultaneously press "+" and "-" to enter the settings. Briefly press "ON/OFF" to change function. Then perform short
presses on "+" and "-" to adjust the settings. Once the changes have been made, press "+" and "-" simultaneously to exit
the settings mode.
P02: Distance unit
0: Kilometers (default choice)
1: Miles
P04: Standby
from 0 to 60 minutes
0 = display always on.
(Default, sleep after 5 minutes)
P09: Starting the scooter with or without pulse
0 = Start without pulse
1 = Start with an impulse (default choice)
31