Prozis Vibrating Massage Roller Bedienungsanleitung Seite 4

EN
• never use the device in very humid environments.
Do not touch the product, the power cord or the power plug with wet hands.
Never open the product casing. This product has no internal parts that require maintenance.
Do not use the product immediately after it has been brought from a cold room into a warm
room. Allow the product to adjust before switching it on.
DANGER! RISK OF INJURY
If you experience any pain or discomfort during the massage, stop immediately and contact
your doctor before using the equipment again.
When using a massage roller for the first time, you may experience pain or bruising. If the
pain is severe and persistent, please consult your doctor.
Follow the instructions and use only as intended.
CAUTION! This symbol highlights dangerous situations which may lead to minor to
moderate injuries, damage, malfunction and/or destruction of the device.
To prevent harm or damage from happening to users or others, make sure to comply
with the below requirements.
• This product is intended for consumers only.
• Misuse of the equipment may lead to injury, so please make sure you use it correctly.
• To avoid pulling a muscle, please warm up before training.
• Do not exceed the maximum recommended load.
• Before using the equipment, make sure your environment is free from any potential inter-
ference.
• Keep the equipment away from sharp objects.
• Always use the product on a flat, smooth surface.
FOR INDOOR USE ONLY.
User manual
PACKAGE CONTENTS
1 × Vibrating Massage Roller
1 × USB Charging Cable
1 × Quick Guide
PRODUCT OVERVIEW: SEE PAGE 2, FIGURE A
1. On/Off switch 2. Battery indicator lights 3. Modes: 1 - 5 4. Charging port 5. Power button
6
MAINTENANCE AND CLEANING
Cleaning:
Switch the product off and remove all plugs before cleaning.
When cleaning the components, do not use aggressive or abrasive cleaning agents or
materials such as scouring milk or steel wool. These could damage the surface of the
appliance.
Protect the device from water drops and water spray.
Only use a clean, dry cloth for cleaning our device and never use any corrosive liquids. Use a
slightly damp cloth and a mild cleaning agent to remove stubborn dirt.
Be sure moisture does not enter the product during cleaning to prevent damage to the
product and subsequent repairs.
STORAGE:
When not in use, store the device in a dry environment, protected from dust and direct
sunlight.
If the device is not going to be used for a long period of time, you should recharge it on a
regular basis. This helps maintain battery performance.
Store your product in the original case provided.
INSTRUCTIONS
HOW TO USE:
Charging the battery
• Insert the USB charging cable into the charging port at the front of the device. Insert the
other end into a USB port.
• The bottom red light will light up to indicate that the device is charging.
• The green LED lights next to the battery percentages will indicate the charging level.
• A light will flash to indicate that the battery is charging at that level.
• The current battery level will be indicated by a light next to the percentage.
• The device is fully charged once all the green LED lights are steady.
• Once fully charged, remove the USB charging cable from the device.
Switching the roller ON/OFF
Set the switch to the ON or OFF position.
Adjusting the intensity
When ON, press the power button once.
Press it once for 900 rpm, twice for 1800 rpm, 3 times for 2700 rpm, 4 times for 3600 rpm,
and 5 times for Rhythm mode.
Press the POWER button at any time to switch off the vibration and for the roller to enter in
standby mode.
EN
7