Decalcification; Technical Data; Troubleshooting - MIA Aquarius 2200 Bedienungsanleitung

Caution danger of burning! Let the appliance cool down enough before
cleaning and storing it.
•
Wipe the unit only with a damp cloth. Never use metallic or sharp edged
cleaning material or sharp cleaning solvents while cleaning to avoid scratches
and damage.
•
Furring up is a common problem in hard water areas, and it is recommended
that a de-scaling fluid is used to remove the deposits (see next chapter).
•
The guarantee covers manufacturing and material faults whereas limestone
removing as part of cleaning and maintenance is not covered.
•
Never store the unit near a heating element - plastic parts of the housing
could melt. Store the unit in a dry place, not reachable for children.

Decalcification

The decalcification interval depends on the hardness of the water and the
frequency of use. Decalcification should be carried out every month. Please use
common decalcification agent (commercially available) and read and follow its
instructions of use closely.
The integrated lime filter inside the appliance (at the spout) can be removed easily
for decalcification. Just lift up and remove. Rinse under clear water to clean. If
necessary soak in water adding a few drops of vinegar. After descaling ensure to
assemble the lime filter again and that it is fixed firmy. Take care that the lime filter
can not come into contact with the hot heating element to avoid damage.

Technical data

220-240V ~ 50 Hz, 1850 - 2200 W
Approx. 1,7 Ltr. capacity
This appliance is tested according to GS and built to CE regulations.

Troubleshooting

Failure Reason
Kettle does not operate Kettle is switched off
Kettle is not connected to the
mains outlet
The unit switches off The bottom of the unit is heavily
too early scaled
The unit does not The lid is not closed properly
switch off
The unit can not be The boil-dry protection has
switched on triggered and the unit has not
cooled down sufficiently
Troubleshooting
Set switch to ON
Connect the plug to
the mains socket
Descale the unit
Close the lid properly
Take the unit from
the base and let cool
down
12