nemaxx M10 Original-Gebrauchsanleitung Seite 5

KEN002COM
2. Product overview
2.1 Alarm speaker. The alarm speaker is used to send out CO alarm warning
and fault warning information.
2.2 ALARM indicator. The ALARM indicator (Red LED) is used to indicate alarm
status of the CO alarm.
2.3 TEST/SILENCE button. The TEST/SILECNE button is used to test the unit
and to silence the unit during alarm. Press and hold to enable TEST function,
Or press and hold about 0.2 second then release to enable SILENCE function.
2.4 FAULT indicator. The FAULT indicator (Yellow LED) is used to indicate fault
or warning status of the CO alarm.
2.5 POWER indicator. The POWER indicator (Green LED) is used to indicate
power status of the CO alarm. The POWER indicator will flash every 30 seconds
3. Understanding your CO alarm:
3.1 Start up
After activation of the alarm, all three LEDs will light up briefly and the CO alarm
confirms start-up with a beep.
After the power is on, 30 seconds before the green LED flash every 3 seconds,
This is preheated state, 30 seconds later the green LED flashing every 30 seconds
indicates the unit is functioning properly.
3.2 Normal operation
The POWER indicator (Green LED) flashes every 30 seconds.
EN
Alarm speaker
ALARM indicator
(Red LED)
TEST/SILENCE button
FAULT indicator
(Yellow LED)
POWER indicator
(Green LED)
5
Version: 1.0k
12.07.2018