Kicker LX Benutzerhandbuch Seite 71

GAIN TRIM: Push the Gain Trim knob to
open Gain Trim settings. Push the knob
again or the Amp Select button to select the
amplifier channel being modified. You can
cut by -9dB or boost by +3dB per amplified
section (AMP1, AMP2, AMP3, & SUB).
This allows you to make minor adjustments
to levels, helping to match outputs, such
as cutting your tweeter channels, while
boosting the mids.
CLIP: The CLIP indicator will illuminate
when the amplifier output is above the
clipping threshold. This only applies to the
amplifier channel currently selected (AMP
SELECT). If you change your Gain, Bass
Boost or SHOCwave setting, you may
notice the CLIP LED become active. This
means your new DSP settings have caused
an output to clip and you should reduce the
gain or compensate in some other way.
HI-PASS | LO-PASS: Push the HI-PASS
or LO-PASS knob to open the crossover
settings. Push the AMP SELECT button to
select the amplifier channel being modified.
The display will show the amplifier channel
being modified, the current crossover (FR:
Full-Range, HP: Hi-Pass, LP: Lo-Pass, BP:
Band-Pass), and the crossover point.
English 71