Kicker LX Benutzerhandbuch Seite 11

Fuse installation should be as close as
possible to the battery, and no further than
18" (45cm) of the battery, and in-line with
the power cable, which is connected to
your LX Amplifier. Make sure the power wire
is routed so that it will not be damaged,
crimped, or shorted. If you ever need to
remove the amplifier from the vehicle after it
has been installed, the ground wire should
be the last wire disconnected from the
amplifier; just the opposite as when you
installed it.
GND REM
≤24"
(60cm)
Pro Tip: All that's left are
Subwoofers, and a
have an audio upgrade that will dominate
any factory system! KICKER amplifiers
make it easy to upgrade to solid bass with
your existing or stock source unit. Ask your
dealer about KICKER upgrades.
English
SUBSONIC
+12V
PWR/
10 Hz 80
PRT
L
HI-LEVEL
INPUT
fuse
remote turn-on
(see page 15)
X-OVER FREQ BANDWIDTH
40 Hz 160 20 Hz 80 1 5
R L R
INPUT OUTPUT
≤18"
(45cm)
12V
battery
KICKER
few cables, and you'll
SPEAKER
KICK EQ+
REMOTE BASS
ground
+ +
- -
11