Kicker LX Benutzerhandbuch Seite 56

Fuse installation should be as close as
possible to the battery, and no further than
18" (45cm) of the battery, and in-line with
the power cable, which is connected to
your LX Amplifier. Make sure the power wire
is routed so that it will not be damaged,
crimped, or shorted. If you ever need to
remove the amplifier from the vehicle after it
has been installed, the ground wire should
be the last wire disconnected from the
amplifier; just the opposite as when you
installed it.
+
-
≤24"
(60cm)
Pro Tip: All that's left are
and a few
upgrade that will dominate any factory
system! KICKER amplifiers make it easy to
upgrade to solid bass with your existing or
stock source unit. Ask your dealer about
KICKER upgrades.
English
PWR/
PRT
HI-LEVEL
INPUT
fuse
remote turn-on
(see page 64)
cables, and you'll have an audio
L
AMP2
INPUT
R
AMP1
AMP2
AMP1 AMP2 AMP3 SUB
≤18"
(45cm)
12V
battery
KS
BRIDGED (L+ AND R-)
+ +
AMP3 SUB
INPUT INPUT
- -
AMP2 AMP3
CONTROLLER/
AMP3 SUB
REMOTE BASS
ground
speakers,
+ + + +
- - - -
56