VEVOR CON-1 Bedienungsanleitung Seite 8

INSTALLATION OF TEMPERATURE SENSOR
1. Carefully unload the low cover at the neck
position by the edge of circuit board with a
screwdriver slotted.
2. Fasten the circuit board with bolt to the wall
straight over sauna heater. Check diagram for
minimum distance (See fig3).
3. Fix the cover to the temperature sensor.
1.Fitted as a safety feature is an overheating controller that prevents the
heater, in the eventuality of some fault, like problem from thermostat.
2.Should the temperature in sauna room reach too high, the spare link in
the sensor unit automatically cuts off the electricity power.
3.When the temperature is back to normal, the spare link will return to its
own position automatically.
LIMIT CONTROL
- 6 -