Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Getting Started
1.
Select the appropriate plug
for your region and fit it to the
power adapter.
Use only the supplied power
adapter and plugs (using
third-party parts will void your
warranty).
2.
Open the stand. Pass the
cable through the lozenge
shaped hole in the stand and
loop the end of the cable over
the cable tidy hook on the rear
of the product.
Do not pass the cable through
the hole in the stand if you're
wall mounting the product.
4
4
3.
Insert the power cable into the
AC power input at the back of
the device.
Please leave your device
plugged in / switched on at all
times. It's designed to be energy
efficient, keeping running costs
to the bare minimum.
4.
Insert the plug into a mains
power outlet. If you're planning
on connecting the device to Wi-
Fi, please make sure the chosen
plug socket is within good range
of your Wi-Fi router.
5.
Position the device on a
stable surface where it is easy
to access and is in clear line of
sight.
Alternatively, you can wall
mount the device using the
hanging holes.
To wall mount use two M3 x 6mm
screws, spaced 190mm (19cm)
apart.
We recommend using a
spirit level to make sure
they're installed level.
(Screws not included).
Device Setup
1.
The device will turn on as soon
as it's plugged into the mains.
Please wait a few seconds while
it loads.
2.
A setup guide will appear
on the display when you use
the device for the first time.
Please follow these step-by-step
instructions to get your device
ready for use.
Automatic Time & Date Synchronisation
This device uses advanced
technology to ensure it keeps
perfect time, and automatically
updates to the correct date and
year – even if it's unplugged for
weeks at a time. It works reliably
in all regions, including those
that practice Daylight Saving
Time (DST).
Time and date settings will be
synchronised automatically if
the device is connected to Wi-Fi,
or you can set these manually
in the Setup Guide or Settings
Menu.
If the device is unplugged it uses
a battery to remember the time
and date settings.
Please replace this battery every
8 to 10 years by following the
steps below.
3.
Setup will take between 10
and 20 minutes to complete,
and you will need a permanent
fine liner or ball point pen and a
scrap piece of paper.
You can change your device
settings at any time via the
Settings Menu. To access the
menu, press the Menu button
on the left-hand side of the
product
.
1.
Keep your device plugged into
the mains.
2.
Remove the battery door
(which is located behind the
stand).
3.
Gently lever out the battery
by inserting a blunt non-
conductive implement (e.g. a
plastic pen lid) into the gap
highlighted by the two arrow
icons.
4.
Carefully insert the new
battery and replace the battery
door.
This device does
not support
batteries with
bitter coatings.
5
Werbung
