Instar IN-9808 Bedienungsanleitung Seite 27

1 - Infrared LEDs
2 - Lense
3 - Photosensor
4 - PIR Detector
5 - Microphone
6 - Audio Output
7 - Network Port
8 - Power Connector
9 - MicroSD Card Slot
10 - WPS / Reset
11 - Status LED
12 - Antenna
Connector
13 - 2x Antennas
14 - IP66
Connector
15 - Rubber-Joint
16 - IP66 Nut
17 - Bracket
4.3. Status LEDs
Status LED
Constantly on
Slow Flashing
Fast Flashing
Off
Go to https://install.instar.com
5 high-powered IR LEDs (nightvision @ 850nm) and 2 switch-
able status LEDs (blue and red, see description below)
Wide-angle (focal length: 4.3mm / field of view: ~ 100º dia.)
Twilight switch for IR LEDs
Integrated Panasonic passive infrared (PIR) motion detector
For noise detection / audio rec. / two-way audio intercom
3.5mm jack for earphone / active speaker
RJ45 LAN port / connector for Cat5e LAN cable or higher
For included 12V / 2A power supply
Slot for MicroSD/SDXC cards (max. 1024GB / 1TB
- 32GB included in the camera -
3 seconds for WPS WiFi setup / 20 seconds for reset
Red: power; blue: network status (Please refer to Section 4.3)
RP-SMA WiFi antenna connector for 2 antennas
3.5 dB Antennas (option: add INSTAR antenna extension
cable)
For sealing cables with IP66 protection. Different scenarios
available for 1-cable, 2-cables, 3-cables
1-cable, 2-cable, 3-cable rubber-joint for different connection
purposes. (Please refer to Section 4.4 for more details)
To close the IP66 connector and to seal the rubber ring
For wall mounting and overhead installation
Blue LED
Connected to WiFi
Connecting via WPS
No connection to WiFi
LED is turned off, or camera is
not plugged into power
Red LED
N/A
Camera at work
Upgrading firmware
LED is turned off, or camera is
not plugged into power
6-EN