Dynatech DA-UD Gebrauchs- Und Wartungsanleitung Seite 8

2. General remarks.
2.1. This certificate is issued as an assessment from a third party for DYNATECH's PRT.83.2.1500 safety gear activation
system. These means cannot be considered as a safety component according to the list provided in annex III of the
Directive 2014/33/EU, so an EU type-examination cannot be issued.
2.2. The aim of this certificate is to describe the assemblies, operation, and conditions of use of the activation system. In
order to be used in connection with the elevator, the Notified Body in charge of the elevator design assessment, may
take into account the measures and conditions shown in this certificate, for which may mention the reference of this
certificate that can, doing so, be considered as an annex of the elevator approval or alternatively issue a certificate
.
by its own
2.3. DYNATECH shall provide for each installation applying these means, instructions of use and maintenance of the
activation system, according to what is stated in this certificate.
2.4. The following documents are enclosed to this certificate:
Number
PRT83-2.1500.C05.00
DYN83-2.15.C09.00
PRT83.2.1500.C06.00
These documents are enclosed in order to provide identification and information about the basic design of the
means.
2.5. This certificate has not an expiry date except in case of design modifications, that the manufacturer must
communicate to this Agency previously to the modifications be effective; changes in the applicable legislation or
technical changes in the standards of reference for which the expiry date shall be the deadline provided by the
regulation or the date when the standard of reference ceases to provide presumption of conformity.
2.6. Revision log.
REV Date
0 2020.06.23
1 2021.09.01
2 2022.09.20
3 2024.02.20
4 2025.01.28
Technical annex to certificate ATI /CA021 rev.4
Date Title
2020.06.15 Plano general versión ventosa
2021.08.30 Plano general vs ventosa salida centrada bobinas desvinculadas
2020.06.15 Plano general versión PWM
Modification
Initial issue
Includes arrangement variation with shaft decoupled from carriage in PRT.83.2.1500/2
Updating to the 2020 edition of the harmonized standards.
Alternative for use of 230 VAC reset coil
Added possibility of using the system in low pit / low overhead cases as mentioned in EN 81-21
- o -
page 5 of 5