Overmax Multipic EZ Bedienungsanleitung Seite 18

IOS CAST
Press the Menu button on the remote control (11, Fig. B). Enter the "App"
icon by pressing the confirmation button on the remote control (10, Fig. B),
EN
select the IOS Cast app, and follow the instructions on the screen.
NIGHTSKY MODE
To activate the star projector mode, press the NightSky star projector switch
(2, Fig. B). To change the image, press the selection buttons (3 and 4, Fig. B).
To deactivate the star projector mode, press the back button (13, Fig. B).
AMBIENTE MODE
To access the Ambiente mode, press the button (5, Fig. B). To change, press
the Ambiente mode switch again. To deactivate the Ambiente mode, press
the back button (13, Fig. B).
CLEANING
1.
Before cleaning the device, unplug the power cord.
2. Clean the housing regularly with a damp cloth.
3. Use an eyeglass tissue or soft cloth to clean the projector lens to avoid
scratches.
4. Regularly clean the projector's vents and speakers with a soft brush to
prevent blockage and ensure proper ventilation. Clean the filter regularly.
TROUBLESHOOTING
Problem
The projector does not
turn on when the switch is
pressed.
The remote control does
not work when operating
the projector.
No image.
Automatic shut-off.
The photos are for illustrative purposes only, the actual appearance of the products
Possible causes
• The power cord is not properly connected.
• The switch is faulty.
• The connected battery is fully discharged
• The remote control has no batteries or the
batteries are depleted.
• Incorrect input source.
• No input signal.
• The input cable is not connected.
• The projector's ventilation is blocked.
• The voltage is not stable.
• The projector has overheated. Check to ensure the
fan is functioning properly.
may differ from that shown in the photos.