Focus Adjustment - Overmax Multipic Ez Bedienungsanleitung

Then connect the cord connecting battery to projector (13, Fig. A) to the projector's
power output port (5, Fig. A) and the projector's charging port (3, Fig. C).
B. To use mains power, connect the power adapter with cord (12, Fig. A)
EN
to the projector's power output port (5, Fig. A) and to a power source.
Correct power supply connection is indicated by the red light on the switch
(1, Fig. A).
ON AND OFF SWITCHING
When the projector is connected to a power source, it enters standby mode,
and the switch on the top of the housing (1, Fig. A) lights up red. To switch
the projector on or off, press the on/off switch or the on/off button on the
remote control (1, Fig. B). Then confirm the operation.
When the projector is powered on and ready for use, the switch on the top
of the housing (1, Fig. A) will illuminate in white.
SETTINGS
Refer to the table below to adjust the image size and projector distance (Fig. 1).
Image diagonal (metres / inches)
Important! During installation, ensure the projector is placed on a stable
surface or mounted on a tripod. Do not cover or block the ventilation openings.
If the distance between the projector and the screen is less than the
minimum distance or significantly greater, the image may be blurred.

FOCUS ADJUSTMENT

1.
Position the projector so that the lens is perpendicular to the wall or
screen where the image will be projected. Depending on preference, the
projector can be tilted up to 45°.
2. To adjust the sharpness of the projected image, turn the focus knob on
the top panel (10, Fig. A) until the image is clear.
ROTATION (FIG. 2)
The swivel base allows the device to be rotated up to 240
Aspect ratio
2.22 / 87.4
2.77 / 109
3.33 / 131.1
3.81 / 150
5.08 / 200
16:9
Projection distance (metres/inches)
2.64 / 104.4
3.3 / 130.8
4 / 157.2
4.15 / 163.3
5.55 / 218.5
o
.