Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cleaning The Spa Tub
If dirt is visible in the water or if the water becomes cloudy and the correct water chemistry does not clear it up, change the water and clean the spa tub. See
the "Spa tub drainage" section on how to drain the spa. While empty, clean and/or replace the filter cartridge. Use a sponge and mild soap solution to wipe
away any soil or stains on the inside of the spa wall. Rinse thoroughly before refilling with clean water.
IMPORTANT: Do not use steel wool, hard brushes or abrasive cleaners.
①
Spa Tub and Air Bladder Repair
Use the enclosed repair patch to repair any puncture:
1. Clean and dry the area to be repaired thoroughly
2. Apply the glue to the PVC patch and quickly attach it onto the damaged surface. (Glue is not included)
3. Smooth the surface to remove any air bubbles and allow it to dry for 5-10 minutes
NOTE: Glue is not included.
1
Water Outlet & Inlet Cap And Air Inlet Cap Instructions
For Spa models with external control box, the following caps are offered in the repair kit:
1. Air inlet cap x 1pc
These caps are used to prevent water leakage when taking off the control box without draining
the water. Please refer to below instructions:
1. Use the wrench to take off the water outlet and inlet covers from the spa tub inner wall, then screw
the water outlet & inlet caps on and tighten. (pic 1 )
2. Separate the control box and spa tub by screwing off connection nuts.
3. Then screw the air inlet cap onto air pipe and tighten. Please make sure the gasket is on its place
to avoid water leakage. (pic 2)
NOTE:
1. Please make sure to unplug the power pack from the electrical receptacle before above actions.
2. In order to ensure proper work, please take off all caps when re-installing the control box.
Deflation Instructions
Spa deflation (MONO-ECO / NAVAL-ECO / DUET-ECO)
1. Open the valve cap by twisting it counter-clockwise. Ensure the valve is clear from debris, sand, or dirt before
releasing.
2. Push the valve button in and turn it clockwise to lock it in the DOWN position.
3. Once deflation is completed, re-place the cap.
Spa Bladder Deflation
1. Open the valve cap to deflate the bladder. For quick deflation, insert the straw (included in the repair
kit) into the valve.
2. Once the deflation is completed, re-place the cap back.
2
pin hole
pin hole
2. Water outlet & inlet cap x 2pcs
18
3
pic 1
pic 2
Werbung
