Linea 2000 DOMO DO91137F Gebrauchsanleitung Seite 51

INSTALLATION
• Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth and
the inside with a wet, lukewarm cloth. Dry the appliance off well.
• Let air circulate freely around the cabinet.
10 cm
• Make sure there is sufficient space to open the door.
A
47,5 cm 84,5 cm
• This cooling unit is not intended for use as a built-in appliance.
• Select a place with a strong, level floor.
• Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources
nearby will cause higher electricity consumption.
• Avoid very moist places. Too much moisture in the air will cause frost to form very quickly in
your freezer.
• Before connecting your freezer to the power supply, check that the voltage stated on the rating
label of your appliance corresponds to the voltage in your home. A different voltage could
damage the appliance.
• The plug is the only way to disconnect the device from the power supply, make sure it is always
easily accessible. To disconnect power to the device, turn off the device and then unplug it.
• After installation, leave the freezer for 6 hours before turning it on. This way the refrigerant can
settle.
• Allow the appliance to run empty for 12 hours so the compartment can cool to the appropriate
temperature.
10 cm
10 cm
B C
44,5 cm
www.domo-elektro.be
C1 D
39 cm 79 cm
7,5
cm
E
76,7 cm
51