Environmental Protection; Cleaning And Maintenance - Concept Rk4210 Bedienungsanleitung

EN
OPERATING INSTRUCTIONS
1. Remove the kettle from the base (6), open the lid (1) using the lid release button
(7) and fill the appliance with cold water within the permitted maximum only.
Note: Make sure that the lid (1) is closed properly, otherwise the kettle can not
turn off automatically.
2. Place the kettle on the base (6); electric contacts will get connected automatically.
Thanks to the central connector design, the kettle can turn around 360° and be
put on the base from any side.
3. Connect the base to the mains.
4. Turn the kettle on by pressing the switch (5).
The operation of the kettle is indicated by a backlight. The kettle lid (1) must be
properly closed when water is being heated.
WARNING!
Do not open the lid during heating or immediately after heating is completed.
Hot steam could scald you!
5. When the boiling point is reached, the kettle automatically switches off and the
backlight goes out. Water heating can be terminated prematurely by moving
the switch (5) to the off position.
6. Remove the kettle from the base (6) and use the hot water.
7. If you want to reheat the water you have just finished boiling, wait for approximately 30 seconds before reactivating
the switch (5).
8. The kettle filter captures all potential impurities while pouring water.
Note: It is not a sign of a defect when a small amount of water droplets appear on the kettle base (7). It is a small amount
of condensed steam, which deactivates the kettle thermostat.

CLEANING AND MAINTENANCE

WARNING!
Prior to each cleaning operation disconnect the lead-in cable of the appliance from el. socket! Prior to start any
handling operation, make sure that the appliance is cooled down!
Use only a wet rag for cleaning surface of the appliance, do not use any cleansers or hard things which could damage
the surface!
Never clean the appliance under running water, never flush it and never immerse the appliance into water!
Scale removal
During common use water impurities are deposited. Use commercially available agents for scale removal (observe
manufacturer's instructions).
Note: Remove the deposits regularly, once a week as a rule – periodicity depends on water hardness and on frequency
of kettle use. The deposits reduce efficiency and service life of the appliance materially.
38
SERVICING
Any extensive maintenance or repair that requires access to the inner parts of the product must be performed by an
expert service centre. The kettle starts to heat up to the set temperature and the display shows the corresponding
mode.

ENVIRONMENTAL PROTECTION

• Packaging materials and obsolete appliances should be recycled.
• The transport box may be disposed of as sorted waste.
• Polyethylene bags shall be handed over for recycling.
Appliance recycling at the end of its service life:
Fig. 1
Changes to the text, design and technical specifications may occur without prior notice and we reserve the right to
make these changes.
This appliance is labelled in accordance with the European Directive 2012/19/EU on Waste Electrical
Equipment (WEEE). The symbol on the product or its packaging indicates that this product does not
belong in household waste. It must be taken to an electrical and electronic equipment recycling
collection point. By ensuring that this product is disposed of correctly, you will help to avoid negative
environmental and human health consequences that would otherwise be caused by improper
disposal of this product. Disposal must be carried out in accordance with waste management
regulations. For more detailed information on recycling this product, please contact your local
authority, your household waste disposal service or the shop where you purchased the product.
This product meets all the basic EU regulation requirements that relate to it.
EN
39