Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5
your location. Remove these conflicts or strong interferences and repeat
the above procedures.
Menu Operation
Please refer to your soundbar user manual for the full menu operation
instructions.
SPKVOL
Opens the rear surround speaker volume sub menu.
SPK L or SPK R. Adjust the volume of each surround speaker.
Choose between VOL +5 and VOL -5.
MUTE. Change this setting to mute the rear speakers. Options are ON
or OFF.
NOTE:
ū The default setting is OFF. If switched ON, the rear surround speakers
will remain muted until they are unmuted, even if the system has been
in standby. Unplugging the soundbar from the mains power supply will
automatically switch muting OFF again.
WLPAIR
Select this to manually pair the subwoofer and (optional) surround
speakers.
WL VER
Shows the current wireless version.
Room calibration and positional
adjustment
The volume of the rear speakers can be adjusted relative to the
soundbar. This manual calibration allows for greater flexibility when
positioning the system components in the room.
The default volume for each component is set to 0 and can be adjusted
from -5 to +5. Based on the listening position, the default volumes
assume a distance of 1.5m from the rear speakers.
Use the <SPKVOL> option in the menu to balance the system to your
preference. Once set, the component volume will adjust with the
soundbar volume to maintain the system balance.
Troubleshooting
Q: Sometimes I notice minor distortions in voices played through the
rear surround speakers (available to purchase separately).
A: This should only occur when a 2.0 channel stereo audio source
is being upmixed to 5.1.4 or 7.1.4 channels. With 2.0 channel audio
formats, vocals are generally intended to be played from the soundbar
only (this is not always the case with multi-channel audio sources).
However, in some circumstances voices from 2.0 channel audio sources
cannot be separated reliably by the Dolby and DTS upmixer; the
result may be that you notice some voices are played through the rear
surround speakers at a low volume, and in some instances these voices
may sound distorted. We recommend that the rear surround speakers
are positioned at least 1m from your listening position and at this
distance any vocal distortion should not be noticeable. If you do notice
this behaviour, you can temporarily mute the rear surround speakers.
To do this:
Long press the
on the remote control or on the soundbar to mute
the rear surround speakers. Long press again to un-mute.
Or, you can use the soundbar menu:
Navigate the soundbar's menu to select <SPKVOL>.
Use
or
to select <MUTE>. Choose from ON or OFF.
NOTE:
ū The default setting is OFF. If switched ON, the rear surround speakers
will remain muted until they are unmuted, even if the system has been
in standby. Unplugging the soundbar from the mains power supply will
automatically switch muting OFF again.
Werbung
