Description; Operating Elements And Connections - Loctite 98548 Bedienungsanleitung

2

Description

2.1

Operating Elements and Connections

1 Power Switch - LED Lamp signals that the switch is on.
2 Operation Mode Switch
3 Speed Adjustment Knob - Adjust the deposit size (0 ~ 10).
4 Vacuum Adjustment Knob - The suck-back of the adhesive after dispensing.
5 Vacuum Delay Timer - Adjustable within 0 ~ 3 sec.
6 Start Interface - Finger switch connection. A higher-ranking controller can
7 Timer Buttons
8 Timer Display - 4-digits display.
9 CCW/CW Switch - CCW: Counterclockwise / CW: Clockwise.
10 Guide Lock - To fix the tube guide.
11 Tube Guide - To support the tube installed in the roller. Max. 2 tubes.
12 Pump Head - To extract liquids from a tube.
13 Tube Holder with locking knobs - To hold max 2 tubes.
14 Power Connection with Fuse T1A fast-acting.
15 Start/Ready Signal Interface - The optional footswitch 97201 is connected
16 Manual Applicator with Finger Switch - Length of PTFE tube: 1 m.
17 Applicator Tip Adapter - different sizes are available, see Section 7.2.
18 PTFE-Tube - (not shown) different sizes are available, see Section 7.2.
6
also start the dispensing cycle.
here. It is also the output for the READY signal.
R.C. Mode - The Remote Control Mode.
Timer Mode - Time range: ~ 99.99 sec.
Cont. Mode - Continuous operation.
- To adjust dispense time from 0.01 ~ 99.99 sec.