General Maintenance - Ronix Rc-1010 Bedienungsanleitung

1) Turn the air compressor on and allow the tanks to fill. The compressor
will shut off when the pressure reaches the preset maximum.
2) Turn the air compressor off.
3) Pull the ring on the safety valve to release air for three to five seconds.
4) The ring pin must be pushed back into position to stop the flow so air
at high pressure.
WARNING!
If air leaks after the ring has been released, or if the valve is stuck
and cannot be actuated by the ring, do not use the air compressor
until the safety valve has been replaced. Use of the air compressor in
this condition could result in serious personal injury.
MAINTENANCE
WARNING!
When servicing use only identical replacement parts.
Use of any other parts may create a hazard or cause product damage.
WARNING!
Always wear eye protection with side shields. Failure to do so could result
in objects being thrown into your eyes resulting in possible serious injury.
WARNING!
Always release all pressure, all pressure, disconnect from power supply,
and allow unit to cool to the touch before cleaning or making repairs on
the air compressor.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are
susceptible to damage from various types of commercial solvents
31
User Manual