Checking The Safety Valve - Ronix Rc-1010 Bedienungsanleitung

2) Pull the ring on the pressure relief valve to release until pressure
gauge reads less than 1.4 bar.
3) Release the ring.
4) Rotate drain valves counterclockwise to open.
5) Tilt tank drain moisture tank into a suitable container.
NOTE:
Condensate is a polluting material and should be disposed of in
compliance with local regulations.
1) If drain valves are clogged, release all air pressure, remove and clean
valves, then reinstall.
DANGER!
Unplug the air compressor and release all air from the tanks before
servicing. Failure to depressurize tanks before attempting to remove
valve cause serious personal injury.
Rotate drain valves clockwise until tightly closed.

CHECKING THE SAFETY VALVE

WARNING!
Do not attempt to tamper with the safety valve.
Anything loosened from this device could fly up and hit you. Failure to
heed this warning could result death or serious personal injury.
The safety valve will automatically release air if the air tank pressure
exceeds the preset maximum. The valve should be checked before
each day of use by pulling the ring by hand.
30
Air Compressor 10L