Zolia ZD THREE Kurzanleitung Seite 3

EN - ZOLIA ZD THREE FOUNTAIN/PET FEEDER
SPECIFICATIONS:
- Voltage: 220 V
- Power: 2.5 W
- Electricity: 5V-85mA
- Cable length: 35 cm
- Water flow rate: 80 L/H
INSTALLATION:
- Insert the foot into the designated slot at the base of the pet feeder
- Attach the feed tank to the base
- Place the pump at the bottom of the fountain tank and ensure it is securely fixed with the
suction cups
- Hang the filter holder on the inner wall of the fountain, then insert the filter inside
(Note: Before installation, soak the filter in clean water for 5 minutes)
- Make sure to fill the water tank before turning on the pump
- Insert the white hose into the hole in the lid, ensuring it is properly connected to the pump
outlet
- Install the water tank in the base of the dispenser
PRECAUTIONS:
- Power stability : Ensure the electrical connection is stable and avoid pulling on the power
cord to prevent damage to the cord or safety risks.
- Cleaning and maintenance : Regularly clean the inside and outside of the dispenser and
fountain to avoid the buildup of food residues and bacteria proliferation. It is recommended to
use mild soap and a soft brush for cleaning.
- Avoid moisture and direct sunlight : Avoid placing the dispenser in humid areas and
exposed to direct sunlight to prevent short circuits and deterioration of plastic parts.
- Quality of food and water : Regularly replace the food and water to avoid leaving them too
long, which could lead to spoilage and affect your pet's health.
- Attention to food type : The dispenser should be used only for pet food. Avoid putting
human food in it.
By following these precautions, you can effectively extend the life of the water fountain while ensuring
the safety and health of your pet's feeding.
2
Thank you for choosing one of our Zolia products !
We hope it brings you complete satisfaction.