Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Remove the battery before storing or transporting
the product.
•
Store the battery and battery charger in a dry,
moisture-free, and frost-free space.
•
Avoid storing the battery in an area where static
electricity may occur, and do not store in a metal
box.
•
Charge the battery 50% before long-term storage.
•
Store the battery charger in a closed and dry space.
•
Keep the battery away from the battery charger
during storage, and ensure that unauthorized
persons, including children, do not touch the
equipment. Store the equipment in a lockable
space.
•
Clean the product and perform full servicing before
long-term storage.
•
Use transportation guards on the product to prevent
injury or damage during transportation and storage.
•
Securely stow the product during transport to ensure
safe handling.
7
TROUBLESHOOTING
Problem
Possible cause
The guide bar
The chain is too
and the chain
tight.
become hot and
The oil tank is
release smoke.
empty.
Contamination
causes a block-
age of the dis-
charge port.
Contamination
causes a block-
age of the oil
tank.
Contamination
causes a block-
age of the guide
bar and the oil
tank cap.
Contamination
causes a block-
age of the
sprocket or
guide wheels.
The motor runs
The chain is too
but the chain
tight.
does not rotate.
The guide bar
and the chain
are damaged.
English
Problem
Solution
Adjust the chain
The motor runs
tension.
and the chain ro-
Add lubricants.
tates, but the
chain does not
cut.
Remove the
guide bar and
clean the dis-
charge port.
Clean the oil
The machine
tank. Add new
does not start.
lubricant.
Clean the guide
bar and the oil
tank cap.
Clean the
sprocket and the
guide wheels.
Adjust the chain
tension.
Replace the
guide bar and
the chain if it is
The motor runs,
necessary.
but the chain
does not cut cor-
rectly, or the mo-
7
Possible cause
Solution
1. Remove the
battery pack
from the ma-
chine.
2. Remove the
guide bar
cover.
3. Remove the
bar and saw
chain.
4. Clean the
The motor is
machine.
damaged.
5. Install battery
pack and op-
erate the ma-
chine.
If the sprocket
rotates, it means
the motor works
properly. If not,
call service cen-
ter.
Sharpen or re-
The chain is
place the saw
blunt.
chain.
The chain is in
Turn the chain
the incorrect di-
loop to the other
rection.
direction.
The chain is tight
Adjust the chain
or loose.
tension.
Make sure that
The machine
the battery re-
and battery are
lease button
not connected
clicks when you
correctly.
install the battery
pack.
The battery level
Charge the bat-
is low.
tery pack.
1. Push the
lock-out but-
The lock out but-
ton and hold
ton and the trig-
it.
ger are not push-
ed at the same
2. Push the trig-
time.
ger to start
the machine.
The battery is
Refer to battery
too hot or too
and charger
cold.
manual.
The machine is
Release the trig-
in the protection
ger and start the
mode to protect
machine again.
the PCB.
EN
Werbung
