Bestway LAY-Z-SPA 60322 Gebrauchsanweisung

WARNING
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
The light source of this luminaire is not replaceable; when the light source reaches its end of life, the whole
luminaire must be replaced.
Battery Precaution
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard (Carbon - Zinc), or rechargeable (Nickel - Cadmium).
• Ensure batteries are installed correctly with regard to polarity (+ and -).
• Do not short-circuit the battery.
• Never attempt to recharge primary batteries as this may cause leakage, fire, or explosion.
• Rechargeable batteries must be removed from this product before being charged.
• Never attempt to disassemble or open batteries as this can lead to chemical burns.
• Remove batteries from equipment that will not be used for an extended period of time.
• Exhausted batteries should be removed from this product.
• Do not dispose of this product and its batteries using fire. Check your local regulations for proper disposal instructions.
• Batteries should not be exposed to excessive heat such as sunshine, fire, etc.
• Keep batteries out of the reach of children.
• Only use AAA batteries (not included).
DISPOSAL
Electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your local authority or retailer for recycling advice.
SETUP INSTRUCTIONS
PARTS & TOOLS NEEDED
Compare the parts in your box to the parts listed in this manual. Verify that the equipment
components represent the model that you had intended to purchase.
ASSEMBLY INSTRUCTIONS
For installation instructions, follow the illustrations inside the manual. Drawings are for illustration
purposes only. May not reflect actual product. Not to scale.
A: For Spas of external pump.
B: For Spas of internal pump.
• If the waterfall falls over, please re-adjust the angle of the base and tighten the nut.
• When the pool is covered, please removed the waterfall.
LED Battery Assembly
• Install 3 AAA batteries (not included).
• Press the button once: Turns product on.
• Press again: Changes to light show.
• Press button and hold for 3 seconds: Turns product off.
NOTE: Keep the product completely dry when you change its batteries. The product will last for up to two
hours after being turned on. Then, it will auto power off.
MAINTENANCE & STORAGE
• Store in a dry place when not in use.
Soothing LED Waterfall
Max.ambient: 45ºC Class 2 circuit
1
Model No.60322
DC 4.5V Max. 0.3W IP66