HOMCOM GDZ40-518E Bedienungsanleitung Seite 11

Unplug the power cord before any cleaning.
The lint filter must be in place whenever
drying and should be cleaned before each
use.
1. Remove the filter:
- Pull out the filter by inserting your fingers
into the four holes around the exhaust
vent shroud.
- The filter consists of three parts: Exhaust
vent shroud, lint filter and exhaust filter
(see Figure 1).
2. Clean the filter:
- Separate the exhaust vent shroud, lint
filter and exhaust filter.
- Using a soft brush or vacuum cleaner,
clean the lint on the lint filter and exhaust
filter. Be careful not to damage the filters
(see Figure 2).
3. Reinstall the filter:
- After cleaning, reassemble the parts in the
following order: exhaust filter, lint filter and
exhaust vent shroud.
- Align the recesses in the centre with the
projection in the centre of the drum,
ensuring it is firmly inserted (see Figure
3).
Cleaning the air intake filter:
- Clean the filter at least once a month.
- Remove the filter by pulling outwards,
holding the upper and lower ends of the air
intake shroud.
- Remove the filter inside the shroud and
clean It with a soft brush.
- Reassemble and reinstall as before.
Cleaning the interior and exterior of the
dryer:
- Do not wash directly with water.
- Do not use thinner, gasoline or alcohol.
- Do not use any type of spray cleaner when
cleaning the interior.
- If the dryer drum becomes stained, clean
the drum with a damp cloth.
- Remove any residue before drying the
next load.
- Clean the cabinet with mild soap and
water. Do not use harsh or abrasive
cleaners – they could damage the dryer.
11
Do not touch the intake
during the drying cycle
due to high temperatures