mondaine stop2go Einrichtungsanleitung Seite 3

1.
Remove the lid from the case back, place two lithium
AA batteries in the clock. Please check that the
batteries are minimum 1.5Volts each.
2.
Press both blue buttons simultaneously with a tiny pin
for about 8-10 seconds to start the searching function
when setting the clock for the first time.
You should see a red light appearing on the bottom
right of the aperture. While looking at the clock, the
hour and minute hand should move, until the hands
will stop at 12 o'clock.
Note: There is a time limit to set the clock, the below steps need to be
executed before the hour hand is at 12.00 again. If not, the process needs
to be restarted from the beginning.
Setting the clock for a second time? Press the M.SET button for 5 seconds.
3.
Take your mobile phone or laptop and go to your
settings. Go to WLAN/WiFi (no app needed).
Click on the name of your WiFi clock and wait for the
message to pop up.
Note: Ensure you are connected to a 2.4GHz frequency.
4.
In case you're connected without internet, click on the
name of your WiFi clock and then select "Keep WiFi
connection".