Huepar RL300HG Bedienungsanleitung Seite 12

• If for example, the unit is knocked or caught by a gust of wind, the
laser prism will stop rotating and the green ADS LED(5)will flash
slowly to show an alarm condition. Check that your datums have not
altered and if all is 0k. Pressthe ADS button again & the laser will reset
to AUTO level.
• This function
f this mode has not been turned on and the laser is disturbed, it is
possible that although a level datum will continue to be produced it
may be at a different height than before.
*Note: The ADS function
doing Gradients or Slopes.
Vertical Leveling
• Place the unit on the rear lay down mount on a firm, generally level
surface. The mount is located on the opposing side of the keypad.
• Pres s thebutton@ ,andtheunitwillpower o nandbegin
automatically self-leveling vertically. This process takes around 15
seconds. When the leveling process is completed, the laser will start
spinning at 600rpm in default, indicating a vertically level datum.
*Note: You do not need to independently level the surface but it does
need to be within ±5 deg of true horizontal.
is used to alert users that the laser has been disturbed.
cannot be activated when in manual mode