AutoAqua Smart AWC Lite Bedienungsanleitung Seite 4

Installation
1. Auto Top Off (ATO)
Step 1 :
Mount the blue sensor (Sl) on the
tank/sump with the magnet, and
adjust the lower sensor to the
normal water level.*
*Please set the sensor away from water outlet and direct light to avoid
bubble interference
Step 2 :
Connect ATO refill tube (P1 pump
inlet Prefilter), then put it in the
ATO reservoir.
Prefilter
The Prefilter
installed
of the diaphragm pump.
ater In
S
ATO Reservoir
**Built-in Anti Siphon Pressureis 30 cm. The height from water level
of tank to tube
The outlet must also ALWAYS be out of the water.
or malfunctions.
:
must be
before the inlet
Anti-Siphon
Pressure 1 feet**
outlet must be smaller
Tank/Sump
Step 3 :
Connect ATO refill tube (P1 pump
outlet O Quad Tube Holder ),
then put it in the tank/sump.
Tank/Sump
than 30 cm.
English