AutoAqua Smart AWC Lite Bedienungsanleitung Seite 5

2. Auto Water Change (AWC)
Step 1 •
Mount the blue sensor
(S1)and adjust the lower
sensor to the normal
water level.*
*Please set the sensor away from water outlet and direct light to avoid
bubble interference
Prefilter
The Prefilter
be installed
the inlet
diaphragm pump
aterJnI
Step 3 :
Connect AWC drain tube (P2
pump inlet O •—Quad Tube
Holder Prefilter), then put
it in the tank/sump.
**Built-in Anti Siphon Pressureis 30 cm. The height from water level
of tank to tube
The outlet must also ALWAYS be out of the water.
Water ChangeVolume
Tank/Sump
or malfunctions.
:
must
befo
of the
Tank/Sump
outlet must be smaller than
Step 2 :
Mount the green sensor
(S2) and adjust the top
sensor to the desired
water level after
draining.*
Step 4 :
Connect AWC drain tube
(P2 pump outlet
Lifter Pump Holder), then
put it in the waste water
container.
Anti-Siphon
Pressure 1 feetH
Waste Water
30 cm.
English
Container