Stahl 8150/5 Serie Betriebsanleitung Seite 32

Safety
3.3 Residual
EN
3.3.1 Explosion Hazard
Despite the device's state-of-the-art
in hazardous
Perform all work steps in hazardous areas with the utmost care at all times!
Possible hazards (residual risks) can be categorised
Mechanical
The device can be compressed
which can result in a loss of leak tightness. This kind of damage can, for example, render the
device's explosion protection partially or fully ineffective. This may result in explosions
causing serious or even fatal injury to persons in the vicinity
Take into account the weight of the device; see specifications
Transport the device only in its original packaging or in equivalent packaging.
Use transporting
and can reliably carry the weight of the device.
Do not place any load on the device.
Check the packaging and the device for damage. Report any damage to R. STAHL
immediately.
Store the device in its original packaging in a dry place (with no condensation),
and make sure that it is stable and protected against the effects of vibrations and knocks.
Do not damage the enclosure, built-in components
Excessive heating or electrostatic
Subsequently
failing to clean it properly or painting/coating
become electrostatically
explosions causing serious or even fatal injury to persons in the vicinity.
Operate the device only within the prescribed operating conditions
(see the type plate and the "Technical data" chapter).
Only allow the manufacturer
conductive paint.
Do not paint the device. Consult R. STAHL before mending flaws such as scratches.
Do not use devices with polyester powder-coated
strong electrostatic
Comply with the area specification
adhesive
Clean the device only with a damp cloth.
6 Control and
Series 8150/5
Risks
areas.
damage
or scratched during transport, mounting or commissioning,
or lifting equipment that is suitable for the size and weight of the device
modifying the device, operating it outside of the permitted conditions,
charged, in turn causing it to produce sparks. This may result in
to paint the device and have this company coat it with special,
charges.
labels.
distribution box
design, explosion hazards cannot be entirely eliminated
according to the following causes:
or seals during mounting
charge
it can cause it to heat up excessively
enclosures in areas where there are
of EN IEC 60079-0 when fitting additional plastic
STAHL
on the packaging.
or to
202162 / 815060300030
2018-04-17