Hold Function; Alarm Function; Installing Battery - Exotek Instruments Mc-60Cpa Anleitung

Pinless Moisture Meters
Manual
iNtRODUCtiON
With the MC-60CPA moisture-measuring instrument, EXOTEK INSTRUMENTS
has introduced a hand-held moisture-measuring unit, incorporating electronic
circuitry perfected over years of development and practical applications with
the latest technology.
It is easy to determine moisture content in wood and building materials
with the contact measurement procedure without destroying the material.
Reliability, durability and a high standard of accuracy are assured by modern
digital components built to cope with the stress of everyday use.
The setting of Card board and Paper groups combined with an automatic �ero-
correction, allow more accurate measurements.
SWitCH-ON
By pressing this key once, if the device is off, the unit is
switched on.
SWitCH-OFF
By pressing this key once, if the device is on, the unit is switched off.
Or: Automatically after approx. 30 seconds if the value does not change.
HOlD – FUNCtiON
If this key is being pressed before measurement is taken, the measured value
is kept „fro�en". Now it is possible to take measurements at places where the
values can't be read directly. The activated HOLD function is indicated with a
colon ":" at the left side of the display. By pressing this key
again, the HOLD-function is de-activated.

AlARM FUNCtiON

The MC-60CPA has the possibility to give an acoustic
alarm in case of an user selectable alarm threshold is
reached or exceeded. This function is most useful for sorting out timbers.
By pressing this key and kept the actual threshold value (L6 – L30) is indicated
and the alarm function is activated. In case this key is pressed again, while the
limit is indicated, the threshold value is being increased by 1% moisture in the
range of 6 – 30%. After 2 sec. the unit is ready to take measurements. To turn
off the alarm function, select only a different function.

iNStAlliNG BAttERY

• Open the battery lid on the backside of the meter.
• Install a 9 volt L6R22.
• Close the lid.
A low voltage is indicated with
the battery needs to be replaced. A new battery should be inserted to achieve
correct measuring results.
MC-60CPA
at the upper left side of the display when
-  -
an automatic �ero-
ENG