Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Problem description
The lamp is turned off.
Power cut always stops cleaning. Repeat cleaning if it's interrupted by power failure.
Trouble with wireless network sig‐
nal.
New router installed or router con‐
figuration changed.
The wireless network signal is
weak.
The wireless signal is disrupted by
microwave oven placed near the
appliance.
12.2 Error codes
When the software error occurs, the display shows error message. You will find the list of
problems in the table below.
Code and description
C2 - the Food Sensor is in the appliance cavity during
Pyrolytic Cleaning.
C3 - the door is not fully closed during Pyrolytic Clean‐
ing.
F111 - Food Sensor is not correctly inserted into the
socket.
F240, F439 - the touch fields on the display do not
work properly.
F601 - there is a problem with Wi-Fi signal.
F604 - the first connection to Wi-Fi failed.
F908 - the appliance system cannot connect with the
control panel.
F602, F603 - Wi-Fi is not available.
1)
When the following error message continues to appear on the display, it means a faulty subsystem may have
been disabled. In such a case contact your dealer or an Authorized Service Centre. If one of these errors occurs,
the rest of the appliance functions will continue to work as usual.
12.3 Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
Cause and remedy
The lamp is burnt out. Replace the lamp.
For details refer to "Care and Cleaning" chapter.
Check if your mobile device is connected to the wireless network. Check
your wireless network and router.
Restart the router.
To configure appliance and mobile device again, refer to "Before first use"
chapter, Wireless connection.
Move router as close to the appliance as possible.
Turn off the microwave oven.
Avoid using microwave oven and the Remote operation of the appliance at
the same time. Microwaves disrupt WiFi signal.
Remedy
Take out the Food Sensor.
Close the door.
Fully plug Food Sensor into the socket.
Clean the surface of the display. Make sure there is no
dirt on the touch fields.
Check your network connection. Refer to "Before first
use" chapter, Wireless connection.
Turn the appliance off and on and try again. Refer to
"Before first use" chapter, Wireless connection.
Turn the appliance off and on.
1)
Turn the appliance off and on.
The necessary data for the service centre is
on the rating plate. The rating plate is located
on the front frame of the appliance. It is
visible when you open the door. Do not
remove the rating plate from the appliance.
ENGLISH
21
Werbung
