Technical Data; Installation - Electrolux ERC07002W8 Benutzerinformation

8 electrolux

TECHNICAL DATA

Dimension
The technical information are situated in the
rating plate on the internal left side of the ap-
pliance and in the energy label.

INSTALLATION

Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar) also, but
for optimum performance install this appli-
ance at a location where the ambient tem-
perature corresponds to the climate class in-
dicated on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Rear spacers
In the bag with the documentation, there
are two spacers which must be fitted as
shown in the figure.
Using fine strokes of hammer put them in
their place.
Height
Width
Depth
Location
The appliance should be installed well away
from sources of heat such as radiators, boil-
ers, direct sunlight etc. Ensure that air can
circulate freely around the back of the cabi-
net. To ensure best performance, if the ap-
pliance is positioned below an overhanging
wall unit, the minimum distance between
the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however,
the appliance should not be positioned be-
low overhanging wall units. Accurate level-
ling is ensured by one or more adjustable
feet at the base of the cabinet.
If the cabinet is placed in a corner and the
side with the hinges facing the wall, the dis-
tance between the wall and the cabinet
must be at least 10 mm to allow the door to
open enough so that the shelves can be re-
moved.
520 mm
525 mm
587 mm