Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Adapting external Remote controls
Your CVR-200 AV can learn the codes from other remote controls, e.g. from a TV remote control (only possible
with infrared remotes). Proceed as follows:
▶ Press the „Menu" button on the device for 3 seconds for it to go into learning mode.
▶ The display then shows „press button on Block-RC". Press any button you want to translate onto another
remote.
▶ Once the display says „Block RC Code accepted", followed by „press button on other RC", pick the button
on the other RC that will then have the same functions as the button on the Block remote.
▶ You will then see „Button code transmitted". From there you can repeat the previous steps until all impor-
tant functions are transferred (up to 50). You can leave the programming by pressing the „Menu" button
on the device again. If you set up faulty connections, just override them with correct ones. The device will
automatically delete the previously programmed data.
▶ To delete any programmed data, simply press the „Back" on the device.
Connect external devices via Bluetooth
Your device is equipped with a modern Bluetooth® interface. This allows you to pair any Bluetooth® source
with the CVR-200 AV. Possible sources are smartphones, Tablet, PCs or media players with Bluetooth® func-
tion. To activate the Bluetooth® function, press the „Source" button until Bluetooth® appears on the display or
press „BT/DVD" on the remote, then activate the Bluetooth function on your external device. The blue LED in
the front blinks if it's searching for a pairing; it is lit up once connected.
Pair an external device to the CVR-200 AV:
On your external device, search for Bluetooth® devices in your surroundings, select your CVR-200AV and
begin the pairing (coupling the devices). In case of problems, or if you need further information about the
pairing, please consult the instruction manual of the device you wish to pair with your CVR-200AV. Afterwards
you can activate the music playback function of your external device and your CVR-200AV will play the music.
Please note that you can only link sources using the built-in Bluetooth® function.
Connect your Bluetooth
With the CVR-200AV you have the possibility to connect a Bluetooth headset via Bluetooth®. Please switch
your headphones to the parry mode. press the „BT Headphone Parring" button on the device to start the parring
mode. If nothing is connected, the blue LED will blink. In this mode the CVR-200AV connects automatically (this may
take a few seconds) and the LED will be lit up. If you would like to deactivate the parring mode again, please hold
down the button „BT Headphone Parring" for approx. 3 seconds.
BEWARE: Your headphones must use the „Handshake" function.
64
®
headset to the CVR-200 AV
®
Werbung
