Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Channel Test:
To check whether all speakers are connected, proceed with the channel test. Press „Channel Test" on the
device to send signals, continually shuffling through the speaker outs. The Display shows, which out is currently
recieving the signal. Please check the corresponding cables if an error occurs and one source does not respond
to the test signal. You can end the test once all speakers have successfully recieved a signal. Just press the
„Channel Test" button for some time until the function stops.
Volume:
Use „VOL +" and „VOL-" buttons on the remote control or the multi-function knob on the device to change the
volume of your system overall.
Please note that for different signal sources, the volume of the CVR-200 AV can vary. This is not a defect but is
caused by different input levels of the connected signal sources. You can customize the volume controls by +/-
10 db separately. Simply keep pressing „A/B" on your remote until you reached the channel you want to adjust.
Balance:
Use the keys „L" and „R" on the remote control to change the balance between the speakers and move to
centralise the sound in the room.
Bass:
To raise or lower the bass, press „Tone" on the remote control until „Bass" appears on the display. Use the „VOL
+" and „VOL-" buttons on the remote control to raise or lower the bass. This function deactivates after a short
time.
treble:
Press „Tone" on the remote control so often, until „Treble" appears in the display. Now press the „VOL +" and
„VOL-" buttons on the remote control to increase or decrease the treble. This function deactivates after a short
time.
DSP-setting (Digital Sound Processing):
Press the „Tone" button.
This key is used to switch between various digital sound enhancements such as „Normal", "Live", „Jazz", „Rock",
„Hall", „Classic", „Pop" and „Stadium", press several times to view the different modes. Try to find out which
setting suits you best, on the „Normal" mode this function is deactivated.
57
Werbung
