Renogy RSP5CPR-G1 Benutzerhandbuch Seite 7

2. Attach the rotating joint to the back of the 5W Solar Panel Charger (A) with the two Hex
Cap Screws (C) and two Washers (F) using the Hex Key (H).
3. Select a spot that gets reliable and consistent sunlight exposure throughout the year to
install your Solar Panel Charger
4. Using the Mounting Bracket (B) as a template and mark the screw holes on the se ected
surface with a pencil
5. If the Solar Panel Charger is to be installed on brick, concrete, or stucco, go to step 6. If
the Solar Panel Charger is to be installed on wood or vinyl, skip step 6.
6 Use a drill (not included) to drill holes where you marked the position Of the mounting
holes and put the Screw Anchors
included) to tap in the Screw Anchors (G).
0
(G) into the holes. You may need a hammer (not
06