Temperature Adjustment - Beko Rho 6320 B Bedienungsanleitung

4 Operation
4.1 Inspection before start
1. The power cord shall not be damaged
or fractured.
2. Please verify the rated current of the
power socket is in line with the requir-
ments in the table above and is equip-
ped with a safety grounding device be-
fore use; otherwise, replace the socket.
4.2 Start and power selection
1. Start
Plug in the power, clockwise turn the
thermostat knob to the "+" mark posi-
tion, then turn on the power switch, the
heater starts to work.
2. Power selection
Under normal circumstances, please
use the maximum power "III" gear for
rapid heating. If the room temperature
reaches a suitable temperature, please
choose a lower power "II" or "I" gear to
reduce energy consumption so as to
prevent the room becoming overhea-
ted.
To use the machine for the
C
first time or to re-insert the
socket, please pay attention
to check whether the plug
and the socket are fitted well.
4.3 Inspection method
Insert the power plug into the socket and
start for use; after about half an hour,
turn off and pull out the plug. Check
whether the plug pins are hot; replace
the socket if so (more than about 50°C)
to avoid burning the plug or even caus-
ing a fire caused by overheating of the
socket due to poor contact.
12 / EN

4.4 Temperature adjustment

During use, if you feel it is necessary to
lower the room temperature since it is
too high, you can use the following ad-
justment modes:
1. Turn the power switch to gear "II" or "I".
2. Counterclockwise turn the thermostat
knob back by a certain angle, for which
it indicates that the set temperature is
lower when the closer to the " - " posi-
tion.
4.5 Stop
Turn the power switch to indication point
"0", and then pull out the power plug.
4.6 Movement of the heater
To move the heater, turn it off first, and
pull out the power plug; then push the
body to make the four casters below the
body to roll.
Oil Filled Heater / User Manual