Worx WX394 Originalbetriebsanleitung Seite 13

WORKING HINTS FOR YOUR
TOOL
If your power tool becomes over heated, set the speed
to maximum and run no load for 2-3 minutes to cool the
motor. SDS-plus tungsten carbide drill bits should always
be used for concrete and masonry.
When drilling in metal, only use HSS drill bits in good
condition. Where possible use a pilot hole before drilling
a large diameter hole.
PROBLEM SOLUTION
1. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, having not used a battery pack
for a prolonged time will reduce the battery pack working
time. This can be corrected after several charge and
discharge operations by charging & working with your
tool. Heavy working conditions such as large screws
into hard wood will use up the battery pack energy faster
than lighter working conditions. Do not re-charge your
battery pack below 0 C and above 30
o
performance.
MAINTENANCE
Remove the battery pack from the tool before carrying
out any adjustment, servicing or maintenance.
Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation
slots. This is normal and will not damage your power
tool.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0
The recommended ambient temperature range for
the charging system during charging is 0
Cordless Rotary Hammer
C as this will affect
o
C-45 C.
o o
C-40 C.
o o
DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Postfach 32 02 16, 50796 Cologne, Germany
On behalf of Positec declare that the product,
Description Battery-operated Hammer
Type WX394 WX394.X (3-designation of machinery,
representative of hammer)
Function Hammering various materials
Complies with the following directives,
2006/42/EC
2011/65/EU&(EU)2015/863
2014/30/EU
Standards conform to
EN IEC 55014-1, EN IEC 55014-2, EN 62841-1, EN
IEC 62841-2-6
The person authorized to compile the technical file,
Name Marcel Filz
Address Positec Germany GmbH
Postfach 32 02 16, 50796 Cologne, Germany
2023/02/08
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China
13
EN