Terraillon INSECT CALM Gebrauchsanweisung Seite 125

The device is intended for use in the electromagnetic environment specified below. The
customer or the user of device should assure that it is used in such an environment.
IEC 60601 test
Immunity test
Electrostatic ±8 kV contact
discharge ±2 kV, ±4 kV,
(ESD) lEC ±8 kV,
61000-4-2 ±15 kV air
± 2 kV for power
Electrical fast supply
transient/burst lines± 1 kV for
IEC 61000-4-4 input/output
lines
± 0.5kV, ± 1 kV
line(s) to lines
SurgeIEC
± 0.5kV, ± 1 kV,
61000-4-5
± 2 kV line(s) to
earth
0 % UT; 0.5
Voltage cycle At 0°, 45°,
90°, 135°, 180°,
dips, short
interruptions 225°, 270°and
and voltage 315° 0 % UT; 1
variations on cycle and 70 %
power supply UT; 25/30 cycles
input lines IEC Single phase:
61000-4-11 at 0° 0 % UT;
250/300 cycles
Power frequency
(50/60 Hz)
30 A/m
magnetic field
IEC 61000-4-8
NOTE: UT is the a.c. mains voltage prior to application of the test level.
EN
Table 2
Declaration - electromagnetic immunity
Compliance
level level
±8 kV contact
±2 kV, ±4 kV,
±8 kV, ±15
kV air
Not applicable
Not applicable
Not applicable
30 A/m
Electromagnetic
environment - guidance
Floors should be wood, concrete
or ceramic tie. If floors are
covered with synthetic material,
the relative humidity should be
at least 30 %.
Mains power quality should be
that of a typical commercial or
hospital environment.
Mains power quality should be
that of a typical commercial or
hospital environment.
Mains power quality should be
that of a typical commercial or
hospital environment. If the user
of the device requires continued
operation during power mains
interruptions, it is recommended
that the device be powered
from an uninterruptible power
supply or a battery.
Power frequency magnetic
fields should be at levels
characteristic of a typical
location in a typical commercial
or hospital environment.
125