Silvercrest SLG 350 D2 Bedienungsanleitung Seite 11

Lamination process
ATTENTION!
► Ensure that there is sufficient space in front
of and behind the laminator . Otherwise, the
laminating pouch will not be ejected com-
pletely from the laminator after lamination .
This could damage the laminating pouch .
1) Slide the laminating pouch slowly and
straight into the slot for manual pouch
insertion with the closed side first . Pay
5
attention to the markings (A4/A5) . Insert the
laminating pouch in the centre between the
two corresponding markings, depending on
the format .
Note
► If, despite this, the pouch is pulled in at an
angle, use the Anti-blocking switch ABS
as described in the Anti-blocking switch
(ABS) section .
2) When you have slid the pouch several
centimetres into the slot for manual pouch
insertion it will automatically be pulled in
5
the rest of the way . Release the laminating
pouch as soon as you notice that it is being
pulled in automatically .
3) The finished laminating pouch is ejected
from the pouch output
Note
Only after hot lamination: When the
►
finished laminating pouch is ejected from
the pouch output
hot and can easily change its shape . For this
reason, let the laminating pouch cool down
for a minute before touching it .
► To improve the lamination result, you can
weigh down a still hot laminating pouch with
a book, a file folder or any other heavy,
flat object . This will help ensure a smooth,
perfect surface .
■ 8 │ GB │ IE
of the laminator .
9
of the laminator, it is
9
4) If you do not want to start another laminat-
ing process, press the On/Off switch I/O
to switch off the appliance . The indicator
0
lights /
6
5) Pull the plug out of the mains socket .
Anti-blocking switch (ABS)
Note
► At the start of the lamination process, the
laminating pouch may be pulled in at an
angle or jam itself inside the appliance .
1) Press and hold the Anti-blocking switch ABS
. The pouch will no longer be drawn in .
q
2) Remove the laminating pouch from the
manual pouch insertion
Anti-blocking switch ABS
3) Re-start the lamination process .
q
Cutting function
Note
► Do not cut pouches until after lamination .
1) Slide the cutting head
The cutting head
ends of the cutting rail
2) Feed the paper/pouch under the cutting
rail .
3
3) Use the markings on the cutting ruler
precisely align the paper/pouch if you want
to shorten or cut at an angle, for example
(see Fig . 3 and 4) .
Fig . 3
go out .
7
and release the
5
.
q
as far as it will go .
4
can be pushed to both
4
.
3
5 6 7 8
1 2 3 4
0
17 18 19 20
7 8 9 10 11 12 13 14 15 16
0 1 2 3 4 5 6
to
1
13 14 15
10 11 12
9
37 38
27 28 29 30 31 32 33 34 35 36
21 22 23 24 25 26