EcoFlow RIVER 2 Max Bedienungsanleitung Seite 6

TROUBLESHOOTING
etails of Error Icon
icon flashes
icon flashes
icon flashes
RECHARGING TIME
icon flashes
RECHARGING TIME
SOHz icon flashes
SDHz
icon flashes
OVERLOAD icon flashes
O OVERLOAD
icon flashes
r-JJHz
icon flashes
OVERLOAD
RECHARGING TIME
icon flashes
OVERLOAD
icon flashes
icon flashes
A If anyalert occursduringthe useof this productandthe alert icondoesnot
disappear after the product
(do not attempt to charge or discharge).
If the above information fails to resolve your problem, please contact customer service
for further support
rrorTyp ecovery
Battery discharge low Normal operation
temperature protection matically when the battery warms up.
Battery discharge high Normal operation
temperature protection matically after the battery cools down.
Normal operation
Battery charging low
matically after the battery temperature
temperature protection
is restored to above 30C (37.40F)
Battery charging high Normal operation
temperature protection matically after the battery cools down.
Normal operation
AC output low-tem-
matically after the ambient tempera
perature protection
ture is restored
Please confirm
outlet of the product are unobstructed.
AC output over-tem-
Normal operation
perature protection
matically once the cause is eliminated
and the temperature
Normal operation
USB-C or car charging
removing the over-powered
overload protection
restarting the machine.
Normal operation
removing the over-powered
restarting the machine. Electrical
AC output overload pliances must be used within the rated
protection power (for the power limit of electr•
cal appliances
please refer
introduction)
Remove the charger and normal oper-
Charging overload
ation will resume automatically
protection
being restarted
Please check
Fan blocking blocked by foreign objects and remove
the cause of the
Failure of communi-
Normal operation
cation between main
matically after being restarted
control board and AC
is restarted, please stop using the product immediately
Method
will resume auto
will resume auto
will resume auto
will resume auto-
will resume auto
that the air inlet and
will resume auto-
decreases.
will resume after
device and
will resume after
device and
ap-
in the X-Boost mode,
to the X-Boost function
after
whether the fan is
error.
will resume auto