Cardigo Dual Gebrauchsanweisung Seite 9

device. The plug must be inserted into the socket with a twisting movement as far as
it will go, so that a firm hold is guaranteed, and the housing is sealed. The red cable
is connected to the positive pole, the brown cable to the negative pole.
• Should your car no longer be in for a long time Operation, please make sure that the
appliance is in this period is disconnected or switched off.
Application:
• Turn the device on by pressing on the power button. The green LED will flash at regu-
lar intervals. Please note that the device may start in pause mode and then enter the
operating mode. Do not move the device.
• The device emits high-frequency tones in intervals of 30 seconds duration. These
are barely perceptible to the human ear. However, martens, mice, and dormice can
usually hear them well. In addition, a flash of light is emitted every minute to scare
the animals.
• The interval switching and the varying frequency of the tones prevent habituation.
• An integrated vibration sensor detects whether the device is being moved or if it is
at a standstill and switches on or off accordingly. At a standstill, when e.g. the car is
parked, the device is active and emits its tones. Whilst driving, the device switches
off and saves battery.
• An installation in vehicles, is possible with the supplied cable ties. For attachment
outside the vehicle, screws are also available. Secure the unit to a suitable location in
the engine compartment or on walls, fences or similar surfaces in the home, garden
or barn with screws or the supplied cable ties. When mounting on a wall, make sure
that there is a no area at the bottom of the wall, which is not covered by the sound.
• If the vehicle or room has already been visited by martens, the animals most proba-
bly have left scent marks in the area. These odors must be removed before installing
the device (in the vehicle best by a motor wash).
• When the vehicle is stationary, the device switches on automatically after approx. 60
seconds, or switches off vibrations generated by the motor or during driving (auto-
matic switch-off). The device is only active when the vehicle is parked. This protects
the car battery (Auto-ON-OFF).
If you would like to use the device in your car, please note that the device
must be removed before a motor wash!
Attention! Important warning when drilling in walls
Before drilling, make sure that there are no gas, water or power lines locat-
ed at the drilling spot. Installation may only be done by competent persons.
Please pay attention to the condition and material of the wall as the included
9