Xaralyn 4114 Bedienungsanleitung Und Sicherheitshinweise Seite 4

• If the bio ethanol burner is overfilled, the excessfuel should be removed before lighting the
bio ethanol burner.
• Spilled liquid is to be removed by using a soft absorbing cloth, and before lighting the bio ethanol burner.
• When the bio ethanol burner is filled, remove the funnel. You can now fully open the latch. The
burner-opening is visible and the bio ethanol burner is ready for use.
• Warning! Never refill a hot orwarm bio ethanol burner. Risk of explosion! Wait at least 30 minutes for the
Xaralyn burner to cool down before refill.
When the bio ethanol burner is filled with bio ethanol for the first time, the ceramic element on the inside will be
saturated completely. The liquid will always remain partly absorbed by the brick. Therefore it is necessary to use more
bio ethanol the first time the burner is filled than the following times (see table on previous page).
Never overfill the
appliance.
Never (re)ignite a hot
appliance.
Lighting the bio ethanol burner
By opening the latch the fire-opening with the ceramic brick becomes visible.
The bio ethanol burner can now be lit by using a long lighter or a long matchstick.
• Warning! In case the flames hit the back of the insert extinguish the fire immediately and check the
troubleshooting section and/or FAQ's on our website.
• Risk of fire! There should never be fire outside the fire-opening.
insert to de-form and damage the paint of the insert.
• The flames cannot be adjusted by using the latch, this should always be completely open during usage to
prevent damage to or bending of the latch.
Extinguish the bio ethanol burner
The bio ethanol burner is to be extinguished using the latch. It is also possible to order a separate cover plate
for this purpose. To prevent the bio ethanol from evaporating, keep the latch closed when the burner is not in
use.
Maintenance
When the bio ethanol burner has been used very often, discolorations on the top can occur. This is normal
and does not harm the quality of the product. Do not use an abrasive product for cleaning the insert. Clean
the surfaces with a moist piece of cloth (black bio ethanol burners) or a non-abrasive stainless steel cleanser
(stainless steel bio ethanol burners). Glass screens can be cleaned with a ceramic cook top cleaner.
Manual Bio Ethanol Burner.indd 6-7
Never pour fuel into a Never pour fuel into a
burning appliance. hot appliance.
Keep pets and children at a
safe distance.
This is dangerous and can also cause the
Check the outer case regularly for fuel overspill:
• Remove the outer case of the bio ethanol burner.
• Ifthe wool inside the outer case is wet, empty the box and wait until the wool is dry again.
• Put it together again.
Quick trouble shooter
problem possible cause
wrong fuel
formation of soot
formation of soot fire-opening is covered with
decoration material
burning time too short wrong fuel (e.g. gel, methylated
spirit)
burning time too short burner has not been filled
completely
flames too high wrong fuel (e.g. gel, methylated
spirit) or draught
flames too low, not burner has not been filled
visible completely
flames too low, not fuel is almost used up
visible
flames do not disappear occurs with larger burner when
after the latch has been it is in the middle of the burning
closed time. Ethanoldamp then seeks a
way out.
Please visit our website for more extensive problem solving.
Warranty
The warranty on this product is 30 years. Any change and/or alteration
unacceptable and will cause the warranty to expire.
Xaralyn reserves the right to make any technical alterations in order to improve the characteristics and/or
safety of the product. Xaralyn cannot be held responsible
misuse or incompetent use of the bio ethanol burner.
Xaralyn thanks you for the confidence in our product and wishes you many years of enjoyment
your purchase.
solution
ONLY use Xaralyn CLIOO
make sure the fire opening is free of
decoration material
ONLY use Xaralyn CLIOO
extinguish the burner. Let it cool down for
at least 30 minutes and then refill
ONLY use Xaralyn CLIOO
prevent draught
extinguish the burner. Let it cool down for
at least 30 minutes and then refill
extinguish the burner. Let it cool down for
at least 30 minutes and then refill
open the latch and quickly close it again to
refrain the oxygen supply.
This can also easily be blown out
to the insert, surface or burner is
for possible damages or personal injuries caused by
with
17-01-19