Steinberg Systems SBS-TW-3C Betriebsanweisungen Seite 16

UNIT
ZERO
ENTER
TARE
3.2. Preparing for use
APPLIANCE LOCATION
The temperature of environment must not be higher than 40°C and the relative humidity should be less
than 85%. Ensure good ventilation in the room in which the device is being used. There should be at least
10 cm distance between each side of the device and the wall or other objects. The device should always be
used when positioned on an even, stable, clean, fireproof and dry surface, and be out of the reach of
children and persons with limited mental and sensory functions. Position the device such that you always
have access to the power plug. The power cord connected to the appliance must be properly grounded
and correspond to the technical details on the product label.
3.3. Device use
NOTE: Before using the device, make sure that it is properly levelled.
3.3.1. USING THE DEVICE
NOTE: After starting the device, the scale will automatically go into weighing mode. "0" and "kg"
will appear on the [1] display. To select a different operating mode, press the [MODE] button.
NOTE: To turn the display backlight on or off, press and hold the [ZERO / BL] button for a few
seconds.
1. Weighing mode
Weighing an object.
a) Change of units:
• Press the [UNIT] button to change the unit of measurement kg > lb.
b) Tare acquisition:
• Place the container or weight on the [2] weighing platform.
• Wait for a while until the device stabilizes.
• Press the [TARE] button, the "1" display will show the "0" value and the "TARE"
message.
After removing the weight, a minus value will appear on the [1] display.
• Press the [TARE] button again to end tare acquisition.
c) Reset:
• Set the weight on the [2] weighing platform.
• To zero the measurement value, press the [ZERO] button.
2. Counting mode
Counting the pieces according to the single piece weight.
a) Press the [SET] button to set the number of samples.
The [1] display will show "SAP X" (where X is the number of samples).
b) Press the [t] button to change the number of samples.
Possible choices are 10, 20, 50, 100, 200.
c) Confirm the selection by pressing [ENTER].
EN
Choice of measurement units
Scale zeroing / backlight
Confirming selection
Tare / Delete tare