Stop Watch Mode; Mode Selection - Conrad Professional Bedienanleitung

9. Stop watch mode

Press the "MODE" key (D) as many times until the stop watch dis-
play appears (see 6.).
Press the "START/STOP" key (A) to start watch timing.
Press the "LAP/SPLIT/RESET" key (B) to take an intermediate time.
A total of 128 intermediate times can be taken with the number of
the intermediate time being shown at top left in the display.
The upper line of numbers shows
you the "LAP" time (the time
since the intermediate time was
taken last time).
The middle line of numbers
shows you the "SPLIT" time (the
time between the time of start
and the point the intermediate
time which was taken).
The stop watch runs in the lower
line of numbers.
Stop taking time by pressing the "START/STOP" time (A). (Start and
stop anew, if desired).
Pressing the "RECALL" key (C) will show you the fastest intermedi-
ate time ("FAST") with the stop watch both running and stopped.
The message inserted into the display is "
The START/STOP" (A) and "LAP/SPLIT/RESET" (B) keys allow to
view the intermediate times which were taken already.
28

6. Mode selection

Simply press the "MODE" key (D) as many times until you see the
desired mode in the LC display.
".
Hour/Date display
Set the alarm time and turn the alarm on/off.
Stop watch mode
Countdown mode
Frequency extrapolation
25