Waterdrop WD-CTF-01 Bedienungsanleitung Seite 5

TIPS:
If there is water leakage at the connecting position between the faucet and the system,it is
recommended to use a wrench to assist in tightening the nut on(C), or use the Teflon tape inside
the instruction package to avoid leakage.
NOTE:
There may be a small amount of black water during the first use.This is a normal
phenomenon because of the activated carbon.Feel free to usethe water after it becomes clear.
1. Switch the lever to the downward direction to get tap water.
2. Switch the lever to the level direction to get pure water.
Figure 1.3
NOTE:
1. Before the first use, run cold water for 3 minutes in the "pure water""position.-
Do not run water at a temperature higher than 100°F/38°C. There may be a small
amount of black water and the sound of water pushing air out of the filter
during the first use.This is a normal phenomenon because of the active carbon.
Feel free to use the water after it becomes clear.
2. Check for water leakage. In the event of leakage,refer to the FAQ or contact
customer service.
For optimum performance, it is highly recommended that you use a genuine Waterdrop
faucet replacement water filter.To keep the water fresh, it is also advisable to change
your filter every 12 months or 8,000 gallons,whichever comes first.This will vary based on
your water usage and water quality.
Use Method
Filter Cartridge Replacement
[Figure 1.3]
[Figure 1.4]
Figure 1.4